![delta rockwell table saw arbor bearings delta rockwell table saw arbor bearings](https://i.ebayimg.com/images/g/39kAAOSwRfxcF9DF/s-l300.jpg)
I made a lot of furniture with it, and it was a pretty good saw. I had one of those saws for almost 20 years. Thanks in advance for any help.looking forward to visiting this site often. Can I put two of the bearings side by side (with a small spacing) and try to press them into the cast iron bearing assembly? The bearings on my old arbor are evidently pressed on and are numbered mrc 5200zz.a double rolled bearing (?) My bearing suppliers have the same bearing but they are not the same width as the bearings I need. And, because of the difference I was able to see in the schematic.I must have the "lower" serial number.though I don't quite understand their system of numbering. I have tried that part number everywhere and either I get an "obsolete" or "cannot find" message.
#Delta rockwell table saw arbor bearings serial numbers#
The schematics say "when replacing Arbor Assembly parts for machines with serial numbers lower than DO-8276 (my serial is DI 8950) it is necessary to order the complete Arbor Bracket Assembly part no. I did find on every website offering Delta repair parts a slightly upgraded type of arbor with a flange and two separate bearings. I was able to remove the arbor and bearing without too much hassle.but when I got online to locate parts I cannot find the correct replacement arbor bearing to fit my saw. Through a process of elimination, I found my Delta table saw (34-400) has a bad arbor bearing that needs replacing. Hopefully, someone can steer me in the right direction with my problem.
![delta rockwell table saw arbor bearings delta rockwell table saw arbor bearings](http://img.auctiva.com/imgdata/1/7/4/5/5/7/1/webimg/657833495_tp.jpg)
From the many posts I've read in this forum.sounds like a lot of knowledge out there on a lot of topics. I found this forum while searching for a solution to a problem with my old Delta table saw. Hello.I am a newbie here.sorry for a previous post in the wrong forum